Current Advance in Materials and Process,
Vol.18, No.4
High Temperature Processes
Lecture No.
Title
Speaker
Page
The present situation of in-process technology and its application to steel-making processes
|
01 |
Global environmental problem and in-process technology
| S.Taniguchi |
......714 |
|
02 |
(Invited Lecture)The present situation of in-process technology and its application in steel-making processes
| Daqiang CANG |
......718 |
|
03 |
Studies for treatment of slag and dust by non-ferrous metallurgical industry and society
| M.Kawahara |
......720 |
|
04 |
(Invited Lecture)Development of technologies for recycling incinerater fly ash and slag
| M.Matsuno |
......724 |
|
05 |
Effective utilization of steelmaking slag for hot metal dephosphorization and stabilization of fluorine
| T.Kaneko |
......728 |
Control of physical limitation on blast furnace operation for minimizing CO2 gas emission |
06 |
Unstable solid descending motion and control in a two dimensional cold model of blast furnace simulating low reducing agents rate operation
| H.Takahashi |
......732 |
|
07 |
Analysis of granular flow in a blast furnace by computer simulation using particles
| J.Hidaka |
......736 |
|
08 |
Prediction of stable and unstable flows in raceway using numerical simulation for gas and granular motions
| T.Umekage |
......740 |
|
09 |
Study on mass flow stability near raceway of blast furnace
| K.Nakano |
......744 |
|
10 |
Development of the visualizing information technique and measurement method of unstable behavior of blast furnace process
| S.Matsuzaki |
......748 |
|
11 |
Analyses on dynamic solid flow in blast furnace lower part for high productivity under intensive coal injection
| Y.Matsui |
......752 |
|
12 |
Effects of packed structure and liquid properties on liquid flow behavior at lower part of blast furnace
| A.Matsuoka |
......756 |
|
13 |
Liquid flow phenomenon and empirical equations for liquid hold-ups in a fixed bed unsoaked initially
| H.Kawabata |
......760 |
|
14 |
Numerical analysis on powder accumulation and its effect on material flows in blast furnace
| H.Nogami |
......764 |
|
15 |
Numerical study on drainage behavior of iron and slag in blast furnace hearth for low reducing agent rate operation
| K.Nishioka |
......768 |
Current Advance in Materials and Process,
Vol.18, No.5
Processing for Quality Products
Lecture No. Title Speaker Page
Controlling of stable threading on sheet and plate production processing |
16 |
Simulation of thickness difference and curvature in plate and hot rolling by rigid plastic FEM
| H.Furumoto |
......1156 |
|
17 |
Steering contorol of steckel rolling mill
| A.Tanaka |
......1160 |
|
18 |
Walking behavior in tandem rolling and tail crash control
| A.Ishii |
......1164 |
|
19 |
Theory of snake motion in tandem rolling
| H.Matsumoto |
......1168 |
|
20 |
Development of walking control technology in hot strip finishing mill
| Y.Washikita |
......1169 |
|
21 |
Strip running simulation on hot run-out-table
| S.Aoe |
......1173 |
|
22 |
Control of strip wandering and buckling in processing lines
| Y.Kaseda |
......1177 |
Latest technologies of tube formability evaluation test |
23 |
Effect of forming length on hydraulic bulging of welded steel tubes
| N.Nishio |
......1181 |
|
24 |
Free bulging test under fixed condition at steel tube ends
| M.Mizumura |
......1185 |
|
25 |
Evaluation method of material properties for steel tube based on free bulge deformation behavior
(Evaluation of yield stress, n-value and r-value-2)
| H.Ohmi |
......1189 |
|
26 |
Processability evaluation of the steel pipe for tube forming by rubber bulge processing
| M.Hirose |
......1193 |
|
27 |
Estimation of formability of steel pipe by ring tensile test
| A.Hino |
......1197 |
|
28 |
Forming limits of a steel tube and a aluminum alloy tube for combined stress path
| K.Yoshida |
......1201 |
|
29 |
Formability evaluation of steel pipes using flaring test
| K.Manabe |
......1203 |
|
30 |
Measurement of fracture strain and r-value distribution of tube using image analysis tension test
| S.Kume |
......1205 |
|
31 |
Forming limit of steel tubes under rotary draw-bending with axial tension
| S.Sakaki |
......1209 |
Current Advance in Materials and Process,
Vol.18, No.6
Microstructure and Properties of Materials
Lecture No. Title Speaker Page
Recent development of computational materials science and engineering for the calculation of phase diagrams, phase transformations, and materials properties |
32 |
Recent advances in computational materials science
| H.Onodera |
......1270 |
|
33 |
Thermodynamic assessment of the Al-Ir system
| T.Abe |
......1272 |
|
34 |
Development of thermodynamic database for Fe-Cr-Mn-Ni-Ti-S-C-N system
| K.Oikawa |
......1276 |
|
35 |
Interface between phase-field program and thermodynamic database
| K.Hashimoto |
......1280 |
|
36 |
Computer simulation of grain growth in dual-phase structure
| I.Ohnuma |
......1282 |
|
37 |
Simulation of the growth of Cu critical nucleus calculated incorporating strain energy in Fe-Cu alloys
| T.Nagano |
......1286 |
|
38 |
The concept of practical computational materials design for the prediction of microstructure evolutions and materials properties
| T.Koyama |
......1290 |
Microstructural evolution during dynamic transformation and dynamic precipitation |
39 |
In situ observation of phase transformation using focused ion beam microscope
| M.Sugiyama |
......1292 |
|
40 |
In-situ observation of weld solidification and transformation process using synchrotron radiation
| Y.Komizo |
......1296 |
|
41 |
In-situ neutron diffraction during thermo-mechanically controlled processing of C-Mn-(Nb) steels
| P.G.Xu |
......1300 |
|
42 |
(ISIJ Research Promotion Grant)The morphology and crystallography of lath and lenticular martensite in steels
| S.Morito |
......1304 |
|
43 |
Deformation-induced martensitic transformation of fine austenite grains dispersed in tempered martensite
| N.Nakada |
......1308 |
|
44 |
Microstructure change and the related phenomena in ultra-high strain PM process
|
H.Fujiwara |
......1311 |
|
45 |
(Invited Lecture)Microstructural evolution during dynamic strain-induced transformation
| H.Beladi |
......1315 |
|
46 |
(Invited Lecture)Dynamic γ → γ transformation in hot deformation of low carbon steels:why is it possible?
| H.Yada |
......1319 |
|
47 |
(Invited Lecture)Effect of applied stress on the austenite to ferrite transformation in low carbon steel
| Hu-Chul Lee |
......1323 |
|
48 |
Coherent-to-incoherent transition of intergranular BCC-precipitates by pre-/post-deformations in a NI-43cr alloy
| Y.Adachi |
......1327 |
|
49 |
(Invited Lecture)Effect of external stress during transformation on orientation characteristics of ferrite
| Dong-Woo Suh |
......1331 |
|
50 |
Necessary heat and metallurgical factors to bring about spontaneous reverse transformation
| T.Yokota |
......1335 |
Availability of nitrogen on improvement in steel properties |
51 |
(ISIJ Research Promotion Grant)Microstructure of high nitrogen austenitic hard steel fabricated through mechanical alloying
| T.Tsuchiyama |
......1339 |
|
52 |
Mechanical properties of hot compacting high nitrogen nanocrystalline austenite stainless steel powders mechanically alloyed
| H.Ogawa |
......1342 |
|
53 |
Microstructure and weldability of high nitrogen stainless steel friction-welded joint
| H.Nishio |
......1345 |
|
54 |
Mechanical properties of a 23Cr-4Ni-2Mo-1N austenitic steel
| M.Ojima |
......1347 |
|
55 |
Effectiveness of solution nitriding in SUS316L stainless steel
| T.Nakanishi |
......1350 |
|
56 |
Cutting performance of low-Ni high nitrogen steels
| M.Matsuzawa |
......1353 |
|
57 |
(Invited Lecture)Precipitations and mechanical properties of high-nitrogen austenitic Fe-18Cr-18Mn-2Mo-0.9N steel
| Sung-Joon Kim |
......1355 |
|
58 |
Effect of aging on microstructures and hardness of high nitrogen austenitic stainless steel
| S.Hoshino |
......1359 |
|
59 |
(ISIJ Research Promotion Grant)Grain boundary engineering of 1mass% nitrogen containing austenitic stainless steel
| H.Kokawa |
......1362 |
|
60 |
Pitting behavior of SUS316 stainless steel alloyed with nitrogen
| H.Yashiro |
......1364 |
|
61 |
Adhesion of nitrifying bacteria on the surface of high nitrogen stainless steel
| Y.Kikuchi |
......1368 |
|
62 |
Low temperature plasma nitriding of high nitrogen stainless steel
| K.Ichii |
......1370 |
Relation between reliability of strength prediction and microstructure evaluation in steels III |
63 |
Relation between yield strength and microstructure in steels with ferrite and cementite structures
| M.Suzuki |
......1373 |
|
64 |
The strengthening mechanizum of tempered martensite steels
| A.Sugimoto |
......1377 |
|
65 |
(ISIJ Research Promotion Grant)Crystallography of bainite and its effect on deformation in bainitic steel
| K.Nakai |
......1380 |
|
66 |
Yield strength and microstructure of bainitic steels
| M.Okatsu |
......1384 |
|
67 |
Critical review on microstructure and strength of pearlitic steels
| T.Shinozaki |
......1388 |
|
68 |
In situ neutron diffraction under tensile deformation for pearlite steels
| T.Suzuki |
......1392 |
|
69 |
Evaluation of material strength using atomistic simulations
| A.Nakatani |
......1396 |
|
70 |
Relationship between lower yield stress and luders elongation for low carbon steels
| N.Tsuchida |
......1400 |
|
71 |
Evaluation of mechanical properties by microtesting technique and its application
| K.Takashima |
......1402 |
Current Advance in Materials and Process,
Vol.18, No.6
Process Evaluation and Material Characterization
Lecture No. Title Speaker Page
Effective pretreatment and sensitive detection methods for steel analysis |
72 |
High efficiency ionization for analysis of oxygen in steel by helium glow discharge
| S.Itoh |
......1644 |
|
73 |
Effect of removal of iron as major component and reduction of background signal on determination of trace elements in iron and steel by high-sensitive spectrochemical analysis
| K.Takada |
......1646 |
|
74 |
Analysis of iron and steels for tramp elements by laser ablation sampling/ICP-MS
| T.Kobayashi |
......1650 |
|
75 |
Determination of trace elements in high-purity iron with a non-ionic surfactant-coated XAD-4 resin
| H.Matsumiya |
......1652 |
|
76 |
Preconcentration technique for trace metals in highly salt samples for ICP-MS
| S.Hirata |
......1654 |
|
77 |
Determination of trace amount of bismuth in iron and steel by reversed- phase high-performance liquid chromatography
| N.Uehara |
......1655 |
|
78 |
FI-system with integrated combination of separation/concentration and detection for determining trace elements
| T.Yamane |
......1656 |
|
79 |
Determination of copper in steel by flow injection-flame atomic absorption spectrometry
| K.Oguma |
......1659 |
Characterization of corrosion-relevant phenomena in steel |
80 |
Analysis of electronic structure of surface oxide films on steels and chracterization of correlated corrosion behavior
| S.Fujimoto |
......1662 |
|
81 |
In situ XAFS measurements of artificial pit for stainless steels
| M.Kaneko |
......1664 |
|
82 |
Corrosion resistannce of stainless steels piping for water supply
| T.Adachi |
......1665 |
|
83 |
Effects of sulfate or silicate ions on conversion of Fe(OH)3 Gel to β -FeOOH and β -Fe2O3
| K.Kanie |
......1669 |
|
84 |
The oxidation mechanism of green rust in an aqueous solution
| K.Kimijima |
......1673 |
|
85 |
Investigation of rust layer formed on steels exposed in atmosphere containing higher air-borne salt content
| T.Kamimura |
......1675 |
|
86 |
Evaluation of rust layer of weathering steels by specific surface area
| T.Nakayama |
......1678 |
|
87 |
(ISIJ Research Promotion Grant)Formation of iron-oxygen-hydrogen compounds on iron surfaces
| S.Suzuki |
......1680 |